PDA

View Full Version : A Catalyst control Center Question



Dingzoom
03-21-2006, 01:46 PM
I have the ATI X800 & have been trying the "CCC" since I went to the ati 6.2 & 6.3 drivers.

I'm not sure whether or not to put a check mark in these boxes; (I really don't know what they are for)

OPEN GL
1) Tripple buffering
2) force 24-bit Z buffer depth

Direct 3D settings
1) enable geometry instancing
2) support DXT texture formats
3) Alternate Pixel center

I have been experiencing a bit of jaggies with the 6.2 & 6.3 dirvers & can't seem to get rid of them completely like I did with the earlier ati drivers.

Dingzoom
03-21-2006, 01:46 PM
I have the ATI X800 & have been trying the "CCC" since I went to the ati 6.2 & 6.3 drivers.

I'm not sure whether or not to put a check mark in these boxes; (I really don't know what they are for)

OPEN GL
1) Tripple buffering
2) force 24-bit Z buffer depth

Direct 3D settings
1) enable geometry instancing
2) support DXT texture formats
3) Alternate Pixel center

I have been experiencing a bit of jaggies with the 6.2 & 6.3 dirvers & can't seem to get rid of them completely like I did with the earlier ati drivers.

vocatx
03-21-2006, 07:16 PM
I run an X800 with 6.3s. I've got all these boxes checked.

Best thing to do is read this: http://forums.ubi.com/eve/forums/a/tpc/f/23110283/m/6651075613

Then go to the "Community Help" forum and find "Coastie's ATI Settings"...the title is something like that. That way you can make an informed decision on the way you set your card.