PDA

View Full Version : CH throttle question... doesn't go below 16% power



sledgehammer2
02-13-2005, 05:28 PM
This isn't keeping me out of the air by any means, but I am just wondering why with the throttle in the full aft position the power wont go below 16%. Anyone ever seen this before and what can I do to get it to 0? I have alot to learn with this thing but I think I will like it! I need to read more about Control Manager and programming the buttons etc... I am not even using so much of what is available on that thing. For example, I haven't even gotten into using the modes yet.

Are there any pre-made profiles for PF fo rthe CH throttle? Thanks for any help.

sledgehammer2

sledgehammer2
02-13-2005, 05:28 PM
This isn't keeping me out of the air by any means, but I am just wondering why with the throttle in the full aft position the power wont go below 16%. Anyone ever seen this before and what can I do to get it to 0? I have alot to learn with this thing but I think I will like it! I need to read more about Control Manager and programming the buttons etc... I am not even using so much of what is available on that thing. For example, I haven't even gotten into using the modes yet.

Are there any pre-made profiles for PF fo rthe CH throttle? Thanks for any help.

sledgehammer2

blairgowrie
02-13-2005, 05:35 PM
I think all you have to do is recalibrate in the Control Manager. I had the same problem a few weeks ago and that's how I fixed it. Easy to do.

sledgehammer2
02-13-2005, 05:48 PM
Umm, ok. I just got the Control Manager v3.6. In fact I had to down;oad it to install my throttle since it came with no disk. but I am not sure I know how to use the CM to calibrate. Do you think you could tell me to do it? If you could I would appreciate it.

blairgowrie
02-13-2005, 06:17 PM
Open Control Manager. Drag your mouse across the little icons in the bar until you see test and calibrate. Click on that to open then just follow the calibration instructions. Should be a no brainer but if you have a problem, please post back here.

Jagdgeschwader2
02-13-2005, 06:19 PM
Here is a visual guide:

1.

http://home.earthlink.net/~jagdgeschwader26/sitebuildercontent/sitebuilderpictures/snap1.jpg

2.
http://home.earthlink.net/~jagdgeschwader26/sitebuildercontent/sitebuilderpictures/snap2.jpg

3.
http://home.earthlink.net/~jagdgeschwader26/sitebuildercontent/sitebuilderpictures/snap3.jpg



Also be sure to visit the CH Hanger for profiles and important information.
www.ch-hangar.com (http://www.ch-hangar.com)


http://home.earthlink.net/~jagdgeschwader26/sitebuildercontent/sitebuilderpictures/jagdgeschwader2s.jpg

sledgehammer2
02-13-2005, 08:14 PM
OK, right after I posted this I went and figured it out. I will check out the CH hangar tomorrow for info. thanks.