PDA

View Full Version : Possible to change a part of a selection?



Groucho2
11-25-2009, 11:23 AM
If you have a selection and wanted to change something that is contained in that selection to a different model is there a way to just replace that part of the selection or is it just easier to create a new selection?

wookash_b
11-25-2009, 12:52 PM
Well if you want to reuse that new selection then anyway you need to create a new selection. Otherwise every time you use that selection you will have to replace the object you want. If you want to just it once then go ahead and Open the group for editing, change the object (swap, add or remove) and Close the group. Now, after that you should have the same selection with your change. If you want to save it for later then I think you should save it.