|
|
You need to set them up while airborn. Launch the quick mission builder, hit fly. Once in-flight, hit escape/ hit controls/ slide down to the bottom, hotas set up. set desired axis's/ hit apply/ return to flight. Rinse and repeat
E8400 3.6Ghz @1.104v P35-DS3Lv2.0(F8fBios)2x2GB A-DATA DDR2800@400Mhz 5-5-5-18@1.8volts(Dual Ch)SATA2Hatachi500GB SapphireHD3870 ver.2.0 (777/1126-flashed w/fanfix bios) Cat 8.6
|
| |
|
|
Try calibrating using the CH control panel. Sometimes this in necassary when installing for the first time or moving to a new USB port. A.K.A.  |
| |
|
|
|
quote: However when I go into IL2 it only seems to recognize the pedals.
That is correct under Win XP. Windows assigns the ID number automatically to your controllers. Your pedals most likely have ID#0, joystick ID#1, etc. You cannot change those assigned numbers, although there was somewhere on the web a little program that allowed to do so, I cannot remember where though. So, Il-2 "thinks" that your primary controller is ID#0, in your case - pedals and therefore you have to go manually through the process of assigning each key to each of the buttons on your stick. |
| |
|
|
Another note, IL2 only supports 4 game devices. If this is your limitation be sure to combine your CH gear with the CH control Manager. ie. I have my FS, PT, PR, and FY combined to 1 logical device. A.K.A. |
| |
|
|
|
| |
| Posts: 8387 | Location: Georgia on my mind | Registered: Sat April 20 2002 |  |
|
