~S~

I have an X52 and my rotaries on the thrust control are sometimes drifting after making a slight trim adjustment. They will continue to decrease. If I adjust the pot again it will correct itself. I go into the control panel and after moving the rotaries from left to right and back a few times it will stabilize. It seems to change between pots for X and Y with no pattern indicated. I am currently running Vista 32 bit. Any ideas would be graeatly appreciated.

Sounds like it may have something to do with the X52's auto calibrate system? Maybe post on the saitek forums?

I have already but haven't got an answer yet.

They can be a little slow over there but eventually UK_Support, aka Richard, should be by with some advise.