View Full Version : F4U-1C (20 mm version) template?
Friendly_flyer
08-21-2007, 12:29 PM
Would anyone know of a F4U-1C template? I have Servals and UF-Josses, but they're all for the 6 x .50 MG versions.
Friendly_flyer
08-21-2007, 12:29 PM
Would anyone know of a F4U-1C template? I have Servals and UF-Josses, but they're all for the 6 x .50 MG versions.
WarWolfe_1
08-21-2007, 05:04 PM
I don't think there is one floating about. You could just use the Void Mech layer, and make a few panel and revit line changes FF.
R_Target
08-21-2007, 07:24 PM
I think the only changes are the ammo hatches and the ejector ports. The barrel housings are taken from somewhere odd, but I forgot where. http://forums.ubi.com/images/smilies/53.gif If you want my wing lines and ports, I could pull them out and send them on.
Friendly_flyer
08-21-2007, 11:56 PM
Thanks Tagert, just what I was looking for! You've got PM.
stansdds
08-22-2007, 03:08 AM
The cannon port fairings are recycled textures from just aft of the ammo boxes. I don't remember which wing, but I know if you try to put the factory stencils for the wing flap release mechanism on the wing they end up on the cannon fairings as well. Really frustrated me trying to figure out that anomaly. http://forums.ubi.com/images/smilies/35.gif
There are two big changes you need to make to the model. The first is to change the ammo box covers from six per wing to four per wing, the outside dimensions remain the same, just four larger covers. The other big change is the bottom of the wing, two larger ejection ports rather than three ports.