X45 Elevator trim ... help required!

[VR_Chalky2005]

Hi Chaps, my prob is this:

I have setup elevator trim on my Saitek X45 with -ROTARY switch 2, so far no prob. BUT, it works in the reverse sense!

I wish to have it so that when I rotate it LEFT, it gives UP trim! RIGHT gives DOWN trim (same as my stick).

Works fine with PF.

Any ideas?

[VR_Chalky2005]

Hi Chaps, my prob is this:

I have setup elevator trim on my Saitek X45 with -ROTARY switch 2, so far no prob. BUT, it works in the reverse sense!

I wish to have it so that when I rotate it LEFT, it gives UP trim! RIGHT gives DOWN trim (same as my stick).

Works fine with PF.

Any ideas?

[WhiskeyRomeo]

All you need to do is use the INVERT button in the lower right hand corner of Axis Input settings screen. Use the OK button after making changes. That should fix you right up.
http://home.earthlink.net/~rgwebster/LO/Pitch06a.jpg

[VR_Chalky2005]

Hi WhiskeyRomeo, Thanks for your reply. I should have spotted that http://forums.ubi.com/images/smilies/1072.gif http://forums.ubi.com/images/smilies/35.gif

Cheers